This course is a follow up to the Manual Basic course and therefore it is recommended that a minimum of six weeks is left between completing the Basic course and attending this course to allow consolidation of previous learning.

The course is comprised of the following elements…

Day 1        

Review of Probe Calibration and Part Alignment

Offset alignment techniques

Use of Best Fit

External storage of data           

RPS Alignment


Day 2        

Use and applications of Loops

Formula Calculation

Use of Minimum / Maximum function

Introduction to Branching and the use of Sub-programs

Application of Head Data


If time permits the following may also be covered on request

Use and set-up of the Security function

Use of Geometric tolerances on the CMM (GD&T)

Get in touch!

For support, to place an order or to make enquiries please call:

01264 353123
8.30am till 5pm - Monday to Friday


Send a Message

FREE Education Pack

Mitutoyo's Education Pack comprises a range of items designed to serve as convenient references to the theory and practice of engineering metrology for use in the classroom, workplace and laboratory.

Claim your FREE pack

Our services

A complete solution - Mitutoyo is not only a vendor of top quality measuring products but one that also offers guaranteed support for the lifetime of the equipment, backed up by comprehensive services.

See our services

*Course length subject to variation depending on which route is taken